Safety System Tests - Challenge CHAMPION 370 TC Instructions And Parts Manual

14.0 Safety System Tests

14.0 Safety System Tests
Machine manufacturer
Serial Number __________________
Frequency of test: THESE TESTS SHOULD BE PERFORMED AT THE BEGINNING OF EACH
WORK DAY.
Turn on the cutter and start the hydraulic motor (see operator's manual for instructions). Enable the
electric eye safety system.
Test #1: Using a 12 mm wide test piece, check the object detection capability of the electric eye
system. Do this by waving the test piece throughout the electric eye beam area. The steady green
and steady orange lights on the emitter side (RH) should change to steady red and flashing orange.
Test #2: Press both cut buttons to begin a cut cycle. During the downward motion of the knife or
clamp, lean into the path of the electric eye beams. The downward motion of the knife and clamp
should stop immediately, and the knife and clamp should return to the "up" position.
If the machine fails either test, DO NOT use machine. Repair or adjustment is necessary.
Please enter date and initials for both tests (make copies of this form if necessary).
Date ______ ______ ______ ______ ______ ______ ______ ______ ______ ______ ______
Test 1 ______ ______ ______ ______ ______ ______ ______ ______ ______ ______ ______
Test 2 ______ ______ ______ ______ ______ ______ ______ ______ ______ ______ ______
Date ______ ______ ______ ______ ______ ______ ______ ______ ______ ______ ______
Test 1 ______ ______ ______ ______ ______ ______ ______ ______ ______ ______ ______
Test 2 ______ ______ ______ ______ ______ ______ ______ ______ ______ ______ ______
Date ______ ______ ______ ______ ______ ______ ______ ______ ______ ______ ______
Test 1 ______ ______ ______ ______ ______ ______ ______ ______ ______ ______ ______
Test 2 ______ ______ ______ ______ ______ ______ ______ ______ ______ ______ ______
Repairs
_________________________________________
_________________________________________
_________________________________________
_________________________________________
_________________________________________
_________________________________________
_________________________________________
116
CHALLENGE Model _____________
Initials of
Repairer
________
________
________
________
________
________
________
Date
_____________
_____________
_____________
_____________
_____________
_____________
_____________