Operating The Mower. 1.18; Height Of Cut - Hayter HARRIER 41 Owner's Handbook Manual

1.18
SAFETY NOTICE
WARNING - PREVENT ACCIDENTAL STARTING:
Always stop the engine and disconnect the spark plug
lead before cleaning, inspecting or working on the ma-
chine. Also disconnect the negative battery lead if the
mower is equipped with electric start.
WARNING - PREVENT ACCIDENTS: Before mowing,
thoroughly inspect the area where the mower is to be
used and remove all objects, which when contacted by
the mower cutterbar could become dangerous projec-
tiles.
Inspect the area for hidden obstructions which when
contacted by the cutterbar could risk health and safety.
Remember the location of these obstructions and ensure
that you mow around them.
IMPORTANT - PREVENT ENGINE DAMAGE: DO
NOT use the mower on a slope greater than 20 degrees.

HEIGHT OF CUT

To adjust the height of cut: Hold the trigger against the
handle and raise or lower the mower using the handle to
achieve the desired cut height. Release the trigger to secure
the mower at the required position.
There are seven height of cut positions. The setting is indi-
cated by the position of the connecting rod relative to the
height of cut indicator.
Always select a height of cut to suit operating conditions.
Aim to prevent engine overloading and blockages by avoid-
ing low cuts in long grass conditions. Be prepared to make
two cuts when the grass is long.
Auto Drive models : When changing height of cut it is
sometimes necessary to re-adjust the clutch cable - refer to
"MAINTENANCE; Clutch cable adjustment."
OPERATING THE MOWER
STOP
1. Engine.
2. Spark Plug Lead.
CS129
3. Spark Plug.
CS031
2 0 MAX.
CS277
305144MA050899A
1.18
1
2
3
CS080
305113