Table of Contents
Advertisement
5. Connect the controller lead on the wiring harness
to the ECU.
6. Install the mount plate to the vehicle frame, under
the dashboard.
A. For the Multi-Pro 1200 and 1250: Install the
mount plate using 2 bolts (5/16 x 3/4 inch), 2
lock washers (5/16 inch), and 2 flat washers as
shown in Figure 14.
4
3
2
1
Figure 14
Frame under the dashboard
1. Bolt (5/16 x 3/4 inch)
2. Lock washer (5/16 inch)
3. Flat washer
B. For the Workman 200 Spray System: Install
the mount plate using 2 U-bolt clamps and 2 nuts
(5/16 inch) as shown in Figure 15.
G016282
Figure 15
1. Vehicle frame
2. U-bolt assembly
5
G016082
4. ECM and Mount plate
5. Vehicle frame
1
2
3
4
3. Mount plate
4. Nut (5/16 inch)
6
Installing the Indicator Light
Parts needed for this procedure:
1
Decal, 94-8582
1
Light assembly
Procedure
1. Install decal 94-8582 over the light hole in the dash
(Figure 16).
1
1. Decal 94-8582
2. Light
2. Install the light in the dash and secure it from
underneath the dash with the push nut (Figure 16).
3. Connect the light to the corresponding connector on
the branch of the wiring harness.
7
Installing the Controls
Parts needed for this procedure:
1
Rocker switch
6
Cable ties
1
Indicator light (Workman 200 only)
1
Grommet (Workman 200 only)
Installing the Controls on a Multi Pro
1200 or 1250 Turf Sprayer
Installing the Switches
9
2
3
G016376
Figure 16
3. Push nut
Advertisement
Table of Contents
