Table of Contents
Advertisement
1. Switch, with notch in the
rear
2. Remove the cover
C. Holding the switch cover in position, flip the
switch body 180 degrees so that the connector
notch is front left corner (Figure 22).
D. Press the rocker switch covers onto the switch
bodies in this new orientation until the cover
snaps into place (Figure 22).
E. Install the switches to their original position in
the control panel.
Note: Ensure that the orientation of the notch
of the switch points toward the top left of the
control box.
Wiring the Switches and Indicator Light
1. Cut and remove the existing grommet in the base of
the control panel. Discard the grommet.
Important: Take precautions not to cut the
existing wires and harness when cutting out the
existing grommet.
2. Route the free end of the wiring harness up through
the opening in the control panel, keeping the branch
with the ring terminal outside the control panel.
3. Split the new grommet included in the kit and wrap
the around the wiring harness at the base of the
control panel.
4. Install the grommets to the base of control panel in
place of the grommet that you removed previously.
5. Connect the connectors labeled "left boom lift
switch" and "right boom lift switch" to the
corresponding panel switches.
Figure 22
3. Switch body, rotated 180°
4. Install cover, notch in the
front
6. Connect the connector labeled "sonic boom switch"
to the sonic boom switch.
7. Connect the light indicator to the wiring harness
with two spade connectors.
8. Install the front control panel cover to the control
box using the fasteners that you removed previously
(Figure 20).
9. Route the remainder of the harness rearward, along
the existing sprayer harness to rear of the machine.
10. Secure the harnesses with cable ties.
Connecting the Wiring to the Fuse Block
1. Locate the branch of the wiring harness, with the
ring terminal for ground and small power terminal,
and route it under the dash to the fuse block area.
2. Connect the ring on the black wire to the ground
bolt (Figure 23).
1. Fuse block
2. Red wire, from harness
3. Corresponding wire, from
fuse block
3. Remove the short extension wire from the red wire
and connect the black connector to the mating
connector in the fuse block.
4. Locate the long branch extending from middle of
the wiring harness with the positive ring terminal.
5. Route the long branch along existing wiring to the
battery area.
6. Remove the battery cover if necessary and connect
the ring terminal to the positive battery post clamp
using existing fasteners.
12
Figure 23
4. Black wire
5. Ground bolt
Advertisement
Table of Contents
