Operation; Using The Controls - Toro Ultra Sonic Boom 41218 Installation Instructions Manual

Operation

Using the Controls

The Sonic boom switch is located on the dashboard
and has 2 settings: Automatic and Manual.
• Automatic mode: This mode enables the
automatic movement of the booms, enabling the
boom tips to continually remain the desired distance
from the ground. To activate the automatic mode,
press the sonic boom Auto mode switch and tap on
the lower boom switch(es) to move the boom to the
desired distance from the ground.
Note: You can temporarily override the automatic
operation of the booms using the boom switches
to raise or lower one or both booms. To lower the
boom manually while the system is in automatic
mode, hold the lower boom switch until you reach
the desired boom height. To raise the boom
manually while the system is in automatic mode,
simply hold the raise boom switch until you reach
the desired boom height. If you adjust only one
boom, the other boom continues to function
automatically. To resume the automatic mode, tap
the lower boom switch to move the boom to the
desired distance from the ground.
• Manual mode: This mode turns off the automatic
adjustment of the booms, and allows you to control
the booms manually.
The Sonic boom light is on the sonic boom switch
displays the status of the sonic boom system as follows:
• On continuously: The sonic boom system is on
and operating normally.
• Flashing quickly: The system is in calibration
mode, which lasts for 20 seconds.
• Flashing slowly: There is an error in the system
or you have overridden the automatic mode by
operating one or both of the booms manually while
the system is in automatic mode.
Note: In the event that there is a fault in the sonic
boom system (e.g., there is no signal coming from a
sensor), the boom will raise for a few seconds and
then stop, and the light on the boom switch (located
on the dashboard) will flash slowly, indicating that
one of the booms has stopped. Also, the indicator
light on the armrest will flash, indicating a fault.
The indicator light is the small red light located on
the arm console and displays the status of the sonic
boom system as follows:
• On momentarily: The light comes on when you
activate the sonic boom system. The light will turn
off after a few seconds and remain off as long as
the system is operating properly.
• Flashing: There is an active fault in the sonic
boom system.
14