Table of Contents
Advertisement
Maintenance
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
After the first 10 hours
Every 50 hours
Every 200 hours
If you leave the key in the ignition switch, someone could accidently start the engine and seriously
injure you or other bystanders.
Remove the key from the ignition before you do any maintenance.
Lubrication
Greasing and Lubrication
Lubricate the machine every 50 hours. Grease more
frequently when operating conditions are extremely
dusty or sandy.
Grease Type: General-purpose grease.
How to Grease
Service Interval: Every 50 hours
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Clean the grease fittings with a rag. Make sure to
scrape any paint off the front of the fitting(s).
4. Connect a grease gun to the fitting. Pump grease
into the fittings until grease begins to ooze out of
the bearings.
5. Wipe up any excess grease.
Where to Add Grease
The grease fitting locations and quantities are:
Bogie pivot assembly –2 (Figure 129)
Maintenance Procedure
• Torque the frame mounting bolts.
• Torque wheel lug nuts.
• Lubricate grease fittings
• Check the tire pressure.
• Torque wheel lug nuts.
1. Bogie pivot assembly (2)
PTO shaft bearings –2 (Figure 130)
Hydraulic cylinder pivot pins –2 (Figure 130)
Lift arm pivot –1 (Figure 130)
44
Figure 129
Advertisement
Table of Contents
