Table of Contents
Advertisement
Maintenance
Note: Determine the left and right sides of the machine from the normal operating position.
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
After the first 8 hours
After the first 50 hours
Before each use or daily
Every 25 hours
Every 100 hours
Every 200 hours
Every 250 hours
Every 400 hours
Every 1,500 hours
Yearly or before storage
Important: Refer to your engine Operator's Manual for additional maintenance procedures.
CAUTION
If you leave the key in the ignition switch, someone could accidently start the engine and seriously injure
you or other bystanders.
Remove the key from the ignition and disconnect the wire from the spark plug before you do any
maintenance. Set the wire aside so that it does not accidentally contact the spark plug.
Premaintenance
Procedures
Before opening any of the covers, stop the engine, remove the
key, and allow the engine to cool.
Important: The fasteners on the covers of this machine
are designed to remain on the cover after removal .
Loosen all of the fasteners on each cover a few turns so
that the cover is loose but still attached, then go back
Maintenance Procedure
• Change the engine oil.
• Check and adjust the track tension.
• Check the engine-oil level.
• Grease the machine. (Grease immediately after every washing.)
• Check the engine oil level.
• Check the condition of and clean the tracks.
• Check the condition of the teeth and rotate or replace any that are worn or damaged.
• Remove debris from the machine.
• Check for loose fasteners.
• Check the hydraulic-fluid level.
• Check the battery electrolyte level.
• Change the engine oil.
• Check the spark plugs.
• Check and adjust the track tension.
• Check the hydraulic lines for leaks, loose fittings, kinked lines, loose mounting
supports, wear, weather, and chemical deterioration and repair if necessary.
• Change the oil filter.
• Replace the fuel filter.
• Replace the hydraulic filter.
• Replace the primary air filter and check the condition of the safety filter
• Check and grease the road wheels.
• Change the hydraulic fluid.
• Replace all moving hydraulic hoses.
• Check and adjust the track tension.
• Touch up chipped paint
and loosen them until the cover comes free. This will
prevent you from accidentally stripping the bolts free
of the retainers.
21
Advertisement
Table of Contents
