Toro 30370 Operator's Manual page 20

1. Drive shaft
6. Route the hoses as follows:
• Route the pressure hose under the lift cylinder
and between the cylinder mounting brackets to
the valve (Figure 45).
• Route the tank hose along side the PTO shaft
to the valve (Figure 45).
Note: To emphasis the hose routing, the hoses
are shown without the hose covers installed.
1. Tank hose
7. Connect the drive shaft to the gear box shaft in the
winter frame and torque the bolts (5/16 inch) to
175-225 in-lb (20 to 25 N⋅m). Install the roll pin
(Figure 46).
Figure 44
2. Frame tube
Figure 45
2. Pressure hose
1. Pressure hose
2. Tank hose
3. Hose cover
8. With the winter frame against the rear frame, raise
the floor jack enough to remove the summer drive
tires (Figure 47). Install the winter tires with 2 lug
nuts per side.
1. Summer drive tire
9. Adjust the floor jack to line up the 1.00 inch holes
in the frame and install a coupler pin on each side
(Figure 48).
20
Figure 46
4. Cable tie
5. Bolts
6. Roll pin
Figure 47