Table of Contents
Advertisement
Maintenance
Note: Determine the left and right sides of the machine from the normal operating position.
Important: The machine may be tipped backward or
on its side to facilitate access for cleaning or service,
but no longer than 2 minutes. If the machine is held in
this position for too long, the engine can be damaged
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
After the first 25 hours
Before each use or daily
Every 50 hours
Every 100 hours
Every 200 hours
Yearly or before storage
Important: Refer to your Engine Operator's Manual for additional maintenance procedures.
Lubrication
Greasing the Machine
Service Interval: Before each use or daily
Grease Type: General-purpose grease.
1. Clean the grease fittings with a rag.
2. Connect a grease gun to each fitting.
3. Lubricate two fittings, one on each cutting wheel
bearing.
4. Pump grease into the fittings until grease begins to
ooze out of the bearings (approximately 3 pumps).
5. Wipe up any excess grease.
Important: Pump grease in slowly and carefully
to prevent damage to the bearing seals.
*Always follow manufacturer instructions*
Maintenance Procedure
• Change the oil.
• Check the engine oil level.
• Grease the machine.
• Check the air filter.
• Check the drive belt tension.
• Check the cutting wheel blades.
• Remove debris from the machine.
• Service the air filter.
• Change the oil.
• Clean the sediment cup.
• Check the spark plugs.
• Replace the drive belt.
• Replace the air filter.
• Change the oil.
• Clean the sediment cup.
*AAA Rent-All 225-291-1356*
by gasoline draining into the crankcase. Should this
happen, perform an extra oil change on the engine.
Then turn the engine over a few revolutions with the
starter handle before starting the engine again.
12
Figure 9
Advertisement
Table of Contents
