Toro 30370 Operator's Manual page 38

Figure 105
1. Two mounting bolts (3/4 inch), washers and nuts (Right
side)
15. Roll the mower deck and frame forward and out
of the way.
16. Loosen the pressure hose fitting at the pump and
rotate the fitting 45 degrees toward the front of the
machine (Figure 106).
Note: Figure 106 is shown as viewed from under
the traction unit.
Figure 106
1. Pump
17. Remove the two screws securing the winter frame
floor plate cover to the floor and remove the plate
(Figure 107).
2. Pressure hosed fitting
(rotated 45 degrees)
1. Floor plate cover
18. Carefully roll the winter frame assembly into
position while routing the drive shaft through the
frame tube (Figure 108).
1. Drive shaft
Note: If the rear of the cab is not high enough to
clear the control handles, evenly tighten the jacking
bolts on each side of the cab jack tube to raise the
rear of the cab (Figure 109).
38
Figure 107
2. Mounting screws
Figure 108
2. Frame tube