Table of Contents
Advertisement
4
Replacing the Boom Cradle
Arms
Parts needed for this procedure:
2
Boom cradle arm
2
Caps
Procedure
The new boom cradle arms allow the booms to fold up
without contacting each other, preventing any possible
damage to the sensors mounted on the booms.
1. Remove the each of the 2 existing boom cradle arms
by removing the bolt and nut (Figure 7).
Note: Save the bolts and nuts to install the new boom
cradle arms.
2
3
1. Cap (2)
2. Boom cradle arm (2)
2. Install each new boom cradle arm and secure it with
the bolt and nut that you previously removed.
1
4
G017146
Figure 7
3. Bolt (2)
4. Nut (2)
5
Installing the Sonic Boom
Sensors
Parts needed for this procedure:
2
Sonic boom sensor
2
Bracket
2
Programming plug
2
Sensor cover
2
Lower sensor housing
2
Cap tube
2
Sensor guard bracket
2
Sensor cable (4 m)
4
Large nut
6
U-bolt
8
Locknut (1/4 inch)
8
Bolt (5/16 x 3/4 inch)
4
Bolt (5/16 x 1-1/4 inch)
12
Locknut (5/16 inch)
12
Cable tie
Procedure
1. Install a mounting bracket on the front side of each
boom near the outermost nozzle with 3 U-bolts and 6
locknuts (1/4 inch) (Figure 8 and Figure 9).
2
1. Mounting bracket (2)
6
1
G017147
Figure 8
Front view
2. U-bolt (6)
Advertisement
Table of Contents
