Adjusting The Control-Arm Position; Installing The Cutting Units - Toro Reelmaster 5010-H Operator's Manual

Important:
Failure to properly grease the
machine will result in premature failure of
critical parts.
6. Open the hood and check the coolant level; refer
to Checking the Coolant Level (page
7. Check the level of the engine-oil level, and close
and latch the hood; refer to
of the Engine Oil (page
Note:
The engine ships with oil in the
crankcase; however, check the oil level before
and after the engine is first started.
2
Adjusting the Control-Arm
Position
No Parts Required
Procedure
You can adjust the control-arm position your comfort.
1. Loosen the 2 bolts securing the control arm to
the retaining bracket
1. Control arm
2. Retaining brackets
2. Rotate the control arm to the desired position
and tighten the 2 bolts.
64).
Checking the Level
50).
(Figure 3).
Figure 3
3. Bolts (2)
3

Installing the Cutting Units

Parts needed for this procedure:
5 Cutting units
Preparing the Machine
CAUTION
If you do not disconnect the power to the
cutting units, someone could accidentally
start the cutting unit, causing serious injury
to hands and feet.
Always separate the power-disconnect
connectors before working on the cutting
units (Figure
1. Unlatch the seat base, tilt the seat and base
open, and support it with the prop rods
4).
1. Latch (seat base)
2. Unplugging the 48 VDC system
battery-disconnect jumper
g004152
12
44).
Figure 4
2. Prop rods
(Figure
(Figure
g375231
5).