Table of Contents
Advertisement
1
Preparing the Machine
No Parts Required
Procedure
Position the machine on a level surface, stop the engine,
remove the ignition key, and engage the parking brake.
CAUTION
If you leave the key in the ignition switch, someone
could accidently start the engine and seriously
injure you or other bystanders.
Remove the key from the ignition switch before you
install the kit.
2
Assembling the Sensor
Mounting Hardware
Parts needed for this procedure:
2
Hinge
2
Angled strap (for an uncovered boom)
2
Angled strap (for a covered boom)
2
Top or bottom strap
4
Compression spring
8
Bushing
4
Hex-head bolt (5/16 x 3-1/4 inch)
12
Flat washer
4
Locknut (5/16 inch)
Procedure
Note: How you assemble the sensor mounting hardware
depends upon whether the Covered Boom Kit (model 41602)
is installed.
1. Lay out the hinges and straps as shown in Figure 1 (for
an uncovered boom) or Figure 2 (for a covered boom).
Note: There are 2 sets of 2 angled straps in loose
parts. One set is for an uncovered boom and the other
set is for a covered boom. You will have one set of 2
angled straps (either for the covered boom or for the
uncovered boom) that you will not use on the machine.
Note: The top straps for the uncovered booms also
serve as the bottom straps for the covered booms.
3
3
For uncovered booms only
1. Hinge (2)
2. Angled strap (2)
1
G017129
For covered booms only
1. Hinge (2)
2. Angled strap (2)
2. Insert the bushings into the welded tube openings in
the hinges and straps as shown in Figure 1 or Figure 2.
3
4
1
2
G017128
Figure 1
3. Bushings (8)
4. Top strap
3
2
3
4
Figure 2
3. Bushing (8)
4. Bottom strap
Advertisement
Table of Contents
