Table of Contents
Advertisement
Maintenance Service
Interval
Every 400 hours
Every 500 hours
Every 600 hours
Every 1,500 hours
Yearly or before storage
Important:
Refer to your engine owner's manual for additional maintenance procedures.
Pre-Maintenance
Procedures
Important:
The fasteners on the covers of this
machine are designed to remain on the cover after
removal. Loosen all fasteners on each cover a few
turns so that the cover is loose but still attached,
then go back and loosen them until the cover
comes free. This prevents you from accidentally
stripping the bolts free of the retainers.
Removing the Front Cover
Important:
The fasteners on the covers of this
machine are designed to remain on the cover after
removal. Loosen all fasteners on each cover a few
turns so that the cover is loose but still attached,
then go back and loosen them until the cover
comes free. This prevents you from accidentally
stripping the bolts free of the retainers.
1.
Park the machine on a level surface, engage the
parking brake, and lower the grinder.
2.
Shut off the engine, remove the key, and allow
the engine to cool.
WARNING
If the machine has been running, both
the cover and the muffler under the cover
will be hot and can cause severe burns
if you touch them.
Allow the machine to cool before
removing the cover.
3.
Remove the front bolt and loose then left bolt
securing the front cover to the machine
24).
Maintenance Procedure
• Change the hydraulic fluid.
• Replace and gap the spark plug(s).
• Replace the inner air filter.
• Replace all moving hydraulic hoses.
• Check and adjust the track tension.
• Touch up chipped paint.
(Figure
1. Cover
2. Remove this bolt.
4.
Slide the cover forward slightly and pull up to
remove the cover
5.
To install the front cover, slide the front cover into
place and secure it with the 2 bolts
Removing the Bottom
Shield
Important:
The fasteners on the covers of this
machine are designed to remain on the cover after
removal. Loosen all fasteners on each cover a few
turns so that the cover is loose but still attached,
then go back and loosen them until the cover
comes free. This prevents you from accidentally
stripping the bolts free of the retainers.
1.
Park the machine on a level surface, engage
the parking brake (if applicable), and lower the
grinder.
2.
Shut off the engine and remove the key.
19
Figure 24
3. Loosen this bolt.
(Figure
24).
(Figure
g319410
24).
Advertisement
Table of Contents
