Jack JK-T1790 Manual page 57

NO.
S39
下缝落针前后修正
Lengthwise compensation of needle entry of basting
进行 2 圈以上的缝制时，设定落针点的前后修正量。
This item sets the amount to move needle entry position back and
forth when performing basting more than two cycles.
S40
下缝落针左右修正
Crosswise compensation of needle entry of basting
进行 2 圈以上的下缝时，设定落针点的左右修正量。
This item sets the amount to move needle entry position to the right
or left when performing basting more than two cycles.
S41
下缝左侧位置修正
Compensation of left side position of basting
设定从左包边中心左右修正下缝的缝制基准位置的修
正量。
This item sets the amount to move the sewing reference position of
basting from the center of left overedging to the right or left.
S42
下缝右侧位置修正
Compensation of right side position of basting
设定从右包边中心左右修正下缝的缝制基准位置的修
正量。
This item sets the amount to move the sewing reference position of
basting from the center of right overedging to the right or left.
S44
下缝速度的设定
Speed setting of basting
设定下缝速度。
This item sets speed of basting.
S45
对缝功能
Sewing together function
选择最初进行对缝。
This item selects the function when performing sewing together first.
：无对缝 Without sewing together
：有对缝 With sewing together
选择了有对缝后按照对缝→下缝→通常缝制的顺序进行缝制。
When "With sewing together" is selected : Sewing is performed in
the order of sewing together→ basting → normal sewing.
项目
Item
- 50 -
设定范围 编辑单位
Setting range Edit unit
0.0～2.5 0.1mm
0.0～1.0 0.1mm
-2.0～2.0 0.1mm
-2.0～2.0 0.1mm
400～4200 100rpm
--- ---
备考
Remarks
---
---
---
---
---
---