Jack JK-T1790 Manual page 31

H
加计数与减计数切换按键；
显示当前选择的计数器
UP COUNTER and DOWN
COUNTER CHANGE OVER
button
Up or down counter display
I
缝制计数器设置画面按键；
显示缝制 的形状总数
COUNTER VALUE CHANGE
button
Total counter values display
J
分步缝制按键
STEP STITCHING button
K
线张力设置按键
显示当前所选择的线张力值
NEEDLE THREAD TENSION
button
NEEDLE THREAD TENSION
mode display
L
显示登记文件的左平行部张力
线张力设置按键
LEFT PARALLEL SECTION
display
NEEDLE THREAD TENSION
button
触摸此键可以进行加计数与减计数切换；
同时显示当前选择的计数器
Press this button, the up counter and down counter can be
changed;
Display of counter which is being selected.
在按键上，显示现在的计数值。按键之后，计数值变更画面被显示
出来。
Exiting counter value is displayed on this button. When the button
is pressed, the counter value change screen is displayed.
按键之后，显示确认落针点，进入重新缝制的步骤缝制画面。
When this button is pressed, the screen of step stitching to check
needle entry point and to perform re-sewing is displayed.
7.
触摸此键可以进行线张力值 1 和 2 之间的转换；
显示当前所选择的线张力值 1 或 2。
When this button is pressed, the needle thread tension mode 1 and
2can be changed.
The needle thread tension mode 1 or 2 which is being selected is
displayed.
用于显示选中缝纫文件的左平行部张力。具体设置见 13。
触摸此键可以进行线张力设置。具体设置见 6。
Left parallel section tension which is set to the pattern data being
selected. Refer to 13.
The button is pressed, the needle thread tension setting screen are
displayed. Refer to 6
- 24 -
Refer to 9.
Refer to