Jack JK-T1790 Manual page 117

NO.
上线张力偏差补正
Compensation of unsteady needle thread
tension
全面补正上线张力的输出值。
Output value of needle thread tension is wholly offset and
compensated.
上线张力变更值输出时间
Output time of needle thread tension changed value
变更了上线张力有关的数据后，仅在设定时间内输出变
更值。
When data related to needle thread tension is changed, the
changed value is output as long as the set-up time.
：无输出 Without output
：设定时间输出 Output of set-up time
每次基准点检索机能
Function of origin retrieval each time
缝制结束后或者循环缝结束后，进行原点检索。
Origin retrieval is performed after completion of sewing.
：无
：缝制结束后 After end of sewing
：循环结束后
倒转针提升 允许/禁止
Needle up by reverse run Effective/ Ineffective
U01 压脚提升最高位置被设定为 14.0mm 以上时，自
动地倒转针提升， 缝纫机停机。 也可以设定禁止此动作。
When U01 Presser lifter maximum position is set to 14.0
mm or more, motion of needle up by reverse run is
automatically performed and the machine stops.
Prohibition of the motion can be set.
： 禁止逆转提升 Needle up by reverse run prohibited
：
许可逆转提升 Needle up by reverse run permitted
设定切刀电磁下降时间
Knife solenoid lowering time setting
设定切刀电磁上升时间
Knife solenoid lifting time setting
项目
Item
Without
After end of cycle
- 110 -
设定范围 编辑单位
Setting Edit unit
range
1
-30∼30
1s
0∼20
－ －
－ －
5ms
25∼100
5ms
5∼100
初期显示
Initial
display
0
0s
Without
output
Effective
35
15