Jack JK-T1790 Manual page 18

（11）暂停开关的固定 Fixing the temporary stop switch
出货时，暂停开关为 A 的状态，请拧松固定螺丝○
固定螺丝○ 固定好。
1
The temporary stop switch has been in the state as shown in figure A at the time of delivery.
Loosen setscrew ○
1
setscrew ○ together with setscrew ○
1
（12）导线杆 Thread guide rod
（13）线架装置的安装 Installing the thread stand
and set the switch in the state as shown in figure B, and fix it with
supplied with the machine.
2
，变更为 B 状态，然后用附属的固定螺丝○
1
请把线导向杆朝向正面插到 2 个的横孔。
Securely fit the thread guide rod so that two
side holes in the thread guide rod face the
thread guide.
1） 安装线架装置，把它安装到机台右上的
孔里。
Assemble the thread stand, and set it in
the hole in the top right corner of the
machine table.
2）拧紧固定螺母○
Tighten locknut ○
stand.
3）如果顶部可以配线时，请把电源线从线
架杆○ 中穿过去。
2
When ceiling wiring is possible, pass
the power cable through spool rest rod
.
○
2
- 11-
和
2
，不让线架装置松动。
1
to fix the thread
1