Jack JK-T1790 Manual page 56

NO.
S32
选择双重缝制交叉
Double stitching cross selection
设定双重缝制时，选择重叠缝制平行部落针或交叉缝制。
This item selects overlapped stitching or cross stitching at the needle
entry of parallel section when setting double stitching.
：双重缝制 Overlapped stitching
：交叉缝制 Cross stitching
S33
修正双重缝制宽度
Compensation of double stitching width
设定双重缝制时，设定缩小第 1 圈的包边宽度量。
This item sets amount to narrow overedging width of 1st cycle when
setting double stitching.
S34
下缝次数
Number of times of basting
设定下缝次数。
This item sets number of times of basting.
：无下缝 Without basting
S35
下缝间距
Basting pitch
设定下缝时的缝制间距。
This item sets pitch at the time of performing basting.
S36
下缝卷入长度
Rolling length of basting
设定进行下缝时的上线卷入缝制长度。
This item sets rolling length of needle thread when performing
basting
S37
下缝卷入间距
Rolling pitch of basting
设定进行下缝时的上线卷入缝制间距。
This item sets rolling pitch of needle thread when performing
basting.
S38
下缝卷入宽度
Rolling width of basting
设定进行下缝时的上线卷入缝制宽度。
This item sets rolling width of needle thread when performing
basting.
项目
Item
：1～9 次 1 to 9 times
- 49 -
设定范围 编辑单位
Setting range Edit unit
--- ---
0.0～2.0 0.1mm
0～9 1
1.0～5.0 0.1mm
2.0～20.0 0.1mm
0.2～5.0 0.1mm
0.0～4.0 0.1mm
备考
Remarks
---
---
---
---
---
---
---