Installing The Auxiliary Handle - Worx WX314 Safety And Operating Manual

OPeratInG InStruCtIOnS
NOTE: Before using the tool, read the instruction
book carefully.
INTENDED USE
The machine is intended for impact drilling in brick,
concrete and stone as well as for drilling in wood, metal
and plastic. Machines with electronic control and right/
left rotation are also suitable for thread-cutting.

1. INSTAllING THE AUxIlIARy HANDlE

(See fig. A)
For your personal safety we recommend using the
Auxiliary Handle(8) at all times.
To fit the handle, loosen the handle by rotating the
bottom section of the handle anti-clockwise and slide
the clamping loop over the handle collar. Rotate the
handle around the handle collar until the handle is
in the desired position. Tighten fully. If you are right
handed fit the handle as shown in A. If you are left
handed fit the handle the other way round.
2. INSTAllING THE DEPTH GAUGE (See fig. b)
The Depth Gauge(2) can be used to set a constant
depth to drill. To use the Depth Gauge, loosen the
handle by rotating the bottom section of handle anti-
clockwise. Insert the Depth Gauge through hole in
handle. Slide the Depth Gauge to required depth and
tighten fully.
3. INSERTING A TOOl INTO CHUCK (See fig. C1)
To open the chuck jaws rotate the front section of the
chuck while holding the rear section. Insert the drill bit
between the chuck jaws and rotate the front section in
the opposite direction while holding the rear section.
Ensure that the drill bit is in the center of the chuck
jaws. Finally, firmly rotate the two separate chuck
sections in opposite directions. Your drill bit is now
locked in the chuck. (See Fig. C2)
Impact drill
A
B
C1
C2
WX314