Installing The Auxiliary Handle - Worx WX314.2 Safety And Operating Manual

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
INTENDED USE
The machine is intended for impact drilling in brick,
concrete and stone as well as for drilling in wood, metal
and plastic. Machines with electronic control and right/
left rotation are also suitable for thread-cutting.

1. INSTALLING THE AUXILIARY HANDLE

(See Fig. A)
For your personal safety we recommend using the
Auxiliary Handle(8) at all times.
To fit the handle, loosen the handle by rotating the
bottom section of the handle anti-clockwise and slide
the clamping loop over the handle collar. Rotate the
handle around the handle collar until the handle is
in the desired position. Tighten fully. If you are right
handed fit the handle as shown in A. If you are left
handed fit the handle the other way round.
WARNING! Always check and rotate the
handle tightly before using to avoid any
accident.
2. INSTALLING THE DEPTH GAUGE (See Fig. B)
The Depth Gauge(2) can be used to set a constant
depth to drill. To use the Depth Gauge, loosen the
handle by rotating the bottom section of handle anti-
clockwise. Insert the Depth Gauge through hole in
handle. Slide the Depth Gauge to required depth and
tighten fully.
3. INSERTING A TOOL INTO CHUCK
(See Fig. C1,C2)
First pull the locking sleeve (a) backward until you hear
a "click" sound. Then, while holding the locking sleeve,
rotate and loosen the front section of the chuck to open
the chuck jaws. Insert the drill bit into the chuck jaws,
and while holding the locking sleeve, rotate and tighten
the front section in the opposite direction. Ensure that
the drill bit is in the center of the chuck jaws. Finally,
push the locking sleeve forward until you hear a "click"
sound. Your drill bit is now locked in the chuck.
Impact drill
A
B
2
C1
1
C2
WX314 WX314.2
7
1
2