Worx WX314 Safety And Operating Manual page 4

do the job better and safer at the rate for
which it was designed.
2) Do not use the power tool if the
switch does not turn it on and off.
Any power tool that cannot be controlled
with the switch is dangerous and must be
repaired.
3) Disconnect the plug from the power
source and/or the battery pack from
the power tool before making any
adjustments, changing accessories,
or storing power tools. Such preventive
safety measures reduce the risk of starting
the power tool accidentally.
4) Store idle power tools out of the
reach of children and do not allow
persons unfamiliar with the power
tool or these instructions to operate
the power tool. Power tools are
dangerous in the hands of untrained users.
5) Maintain power tools. Check for
misalignment or binding of moving
parts, breakage of parts and any other
condition that may affect the power
tool's operation. If damaged, have the
power tool repaired before use. Many
accidents are caused by poorly maintained
power tools.
6) Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to bind
and are easier to control.
7) Use the power tool, accessories and
tool bits etc. in accordance with these
instructions, taking into account the
working conditions and the work to
be performed. Use of the power tool for
operations different from those intended
could result in a hazardous situation.
5. Service
1) Have your power tool serviced by
a qualified repair person using only
identical replacement parts. This will
ensure that the safety of the power tool is
maintained.
Impact drill
aDDItIOnal Safety
InStruCtIOnS fOr yOur
DrIll
1. Wear ear protectors when impact
drilling. Exposure to noise can cause
hearing loss.
2. Use auxiliary handles supplied with
the tool. Loss of control can cause
personal injury.
3. Hold power tools by insulated
gripping surfaces when performing
an operation where the cutting tool
may contact hidden wiring or its own
cord. Cutting accessory contacting a "live"
wire may make exposed metal parts of
the power tool "live" and could give the
operator an electric shock.
4. Do not use the drill near water.
5. Do not use the drill as a screwdriver.
6. Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
7 . Fully unwind extension cords to avoid
potential overheating.
8. When an extension cord is required you
must ensure it has the correct ampere
rating for your power tool and that it is in a
safe electrical condition.
9. Ensure your supply voltage is the same as
your tool rating plate voltage.
10. Your tool is double insulated for additional
protection against a possible electrical
insulation failure within the tool.
11. Always check walls and ceilings to avoid
hidden power cables and pipes.
12. After long working periods, external metal
parts and accessories could be hot.
13. Wear eye protection when operating this
tool.
14. Maintain a firm grip on the handle when
you are working. Always use the auxiliary
handles supplied with the tool. Loss of
control can cause personal injury.
WX314