Advertisement
6
Adjusting the Transport
Position for Cutting Units 6
and 7
Machines Transported on Public
Roads
No Parts Required
Procedure
Important:
If the transport frame is transported
on a public road, the overall width of the frame
and the mowers may not exceed 2.4 m (8 ft).
Adjust the mounting position of the clevis on the end
of the lift cylinders and the mounting position of the
arm stops to the desired width shown in
Figure 17
1. 48 to 51 inches (122 to
130 cm)
Figure
17.
g012721
2. 24-3/4 ± 1-1/2 inches (63
± 4 cm)
7
Installing the Hydraulic
Hoses
Parts needed for this procedure:
2
Hose (long)
2
Hose (short)
Procedure
1.
Install the long hose between the short 90° fitting
in the control valve and the 90° fitting in the
retract port of the lift cylinder (
1. Hose (short)
2. 90° fitting (extend port—lift
cylinder)
3. Hose (long)
2.
Install the short hose between the long 90° fitting
in the control valve and the 90° fitting in the
retract port of the lift cylinder
8
Figure 18
4. 90° fitting (retract port—lift
cylinder)
5. Short 90° fitting (control
valve)
6. Long 90° fitting (control
valve)
(Figure
18).
g322378
Advertisement
