Advertisement
4.
Use a piece of tape to mark the lift cylinders 6
and 7.
Installing the Cylinder Rest
1.
Align the holes in the cylinder rest with the 12.7
mm (1/2 inch)–diameter holes in the bottom of
the cross channels
1. Tapered washer
2. Capscrew (1/2 x 1-1/2
inches)
3. Cross channel
2.
Secure the cylinder rest to the cross channels
(Figure
8) with the 2 capscrews (1/2 x 1-1/2
inches), 2 tapered washers, and 2 flange
locknuts (1/2 inch).
3.
Repeat steps
1
and
at the other side of the machine.
(Figure
8)
Figure 8
4. Flange locknuts (1/2 inch)
5. Cylinder rest
2
for the other cylinder rest
Assembling the Lift Cylinders to
the Machine
1.
Align the holes in the 2 spacer tubes and the
holes in the flanges of the cutting-unit 6 lift
cylinder with the 25 mm (1 inch)-diameter holes
in the top of cross channels
1. Spacer tube
2. Cylinder body
g322311
2.
Assemble the shaft—25 x 305 mm (1 x 12
inches) through the spacer tubes and the
cylinder-body flanges
1. Cotter pins (3/16 x 1-3/4
inches)
3.
Secure the shaft to the cross channels
10) with 2 cotter pins (3/16 x 1-3/4 inches).
4.
Repeat steps
lift cylinder at the other side of the machine.
4
(Figure
9).
Figure 9
3. Cross channels
(Figure
10).
Figure 10
2. Shaft—25 x 305 mm (1 x
12 inches)
1
through
3
for the cutting-unit 7
g322309
g322310
(Figure
Advertisement
