Advertisement
levers move freely. Readjust control-rod link if
necessary.
Figure 31
checking the lever travel and alignment
1. Knob (lower position)
6.
At the control valve, secure the control-rod link
to the control lever with a cotter pin
Figure 32
1. Clevis pin (control lever)
7.
Tighten the nut (7/16 inch) on the control rod
and link; refer to
(Figure
Figure 33
1. Control-rod tube
2. Nut (7/16 inch)
8.
Repeat steps
6
and
machine.
2. Knob (raise position)
(Figure
2. Cotter pin
33).
3. Control-rod link
7
for the other side of the
13
Installing the Reelmaster
Cutting Units
No Parts Required
g322278
Procedure
1.
Align the holes in the drawbar with the holes in
the brackets on the cross-tubes of the cutting
units.
2.
Secure each side
3-1/2 inch), spacer tube, and locknut (1/2 inch).
32).
Important:
inboard.
g322436
1. Bolt, spacer tube, and
locknut
Note:
If you are installing Spartan mowers to
the transport frame, use drawbar clamp Part
No. 5-1090. Mounting fasteners are needed
to mount the drawbar to the front of the mower
cross tube. Contact your local authorized Toro
distributor for assistance.
g323859
3.
If you installed 18-inch wheels on the cutting
units, use Toro Conversion Kit, Part No. 51-3060
to allow the cutting units to raise to the transport
position. Contact your local authorized Toro
distributor for assistance.
4.
Secure the lift chain to the lift arm and the cutting
unit mounting bracket with the long shackles,
clevis pins and cotter pins
13
(Figure
34) with a bolt (1/2 x
Position the head of the bolt
Figure 34
2. Mounting bracket
(Figure
35).
g012725
Advertisement
