Advertisement
Installing the Lift-Arm Stop
1.
Align the holes in the lift-arm stop with the 12.7
mm (1/2 inch)–diameter holes in the top of the
cross channels as shown in
1. Capscrew (1/2 x 1-1/2
inches)
2. Lift-arm stop
3. Cross channel
2.
Secure the lift-arm stop to the cross channels
(Figure
11) with the 2 capscrews (1/2 x 1-1/2
inches), 2 tapered washers, and 2 flange
locknuts (1/2 inch).
3.
Repeat steps
1
and
other side of the machine.
4
Preparing the Lift Arms
Parts needed for this procedure:
2
Link
2
Shaft—25 x 102 mm (1 x 4 inches)
4
Washer (3/8 x 1-5/8 inches)
4
Lock washer (3/8 inch)
4
Capscrew (3/8 x 1 inch)
Procedure
1.
Align the holes in the link with the hole in the
bushing housing of the lift arm as shown in
Figure
12.
Figure
11.
Figure 11
4. Flange locknuts (1/2 inch)
5. Tapered washer
2
for the lift-arm stop at the
g322332
1. Link
2. Bushing housing (lift arm)
3. Capscrew (3/8 x 1 inch)
2.
Assemble the shaft—25 x 102 mm (1 x 4 inches)
through the holes in the link and the bushing
housing
(Figure
3.
Secure the shaft to the link with
capscrews (3/8 x 1 inch), 2 lock washers (3/8
inch), and 2 washers (3/8 x 1-5/8 inches).
4.
Repeat steps
and link.
5
Figure 12
4. Lock washer (3/8 inch)
5. Washer (3/8 x 1-5/8
inches)
6. Shaft—25 x 102 mm (1 x
4 inches)
12).
(Figure
1
through
3
for the other lift arm
g322276
12) 2
Advertisement
