Advertisement
Figure 27
1. Clevis pin
2. Lever block
2.
Secure the rod to the block with a clevis pin and
cotter pin
(Figure
3.
At the control valve, assemble the control-rod
link onto the clevis pin that is pressed into the
control lever
(Figure
Note:
Do not install the cotter pin.
Figure 28
1. Clevis pin (control lever)
4.
Compare the alignment of the lever for the
control rod that you are installing with the levers
for cutting-unit 4, cutting-unit 1, 2, and 3, and
cutting-unit 5
(Figure
3. Cotter pin
4. Control rod
27).
28).
2. Control-rod link
29).
1. Control-rod tube
2. Nut (7/16 inch)
5.
If the lever for the control rod is not aligned with
the rest of the levers, separate the control-rod
link from the control lever clevis pin, rotate the
g322271
control-rod link to align the lever
and assemble the control-rod link to the control
lever clevis pin
6.
Repeat steps
rod.
Installing the Control-Console
Cover
1.
Align the cover over the levers
1. Knob
2. Lever
g322280
3. Cover
2.
Align the holes in the cover with the hole in the
weld nuts of the control console.
3.
Secure the cover to the console
the 4 flange-head screws that you removed in
Removing the Control-Console Cover (page
4.
Thread the 3 knobs that you removed in
Removing the Control-Console Cover (page 10)
and the 2 knobs from the 5 to 7 conversion kit
onto the levers
5.
Check the control levers by moving them to
the raise and lower positions. Ensure that all
12
Figure 29
3. Control-rod link
(Figure
(Figure
28).
1
through
5
for the other control
(Figure
Figure 30
4. Flange-head screw
5. Control console
(Figure
(Figure
30).
g322279
29),
30).
g322282
30) with
10).
Advertisement
