Toro Reelmaster 33452 Operator's Manual page 6

5
Installing the Lift Arms and
Draw Bars
Parts needed for this procedure:
2 Locknut (3/4 inch)
2 Lift-bail pin
2 Capscrew (5/16 x 3/4 inch)
4 Washer (1-1/8 x 2 inches)
2 Shaft—25 x 102 mm (1 x 4 inches)
4 Capscrew (3/8 x 1 inch)
4 Lock washer (3/8 inch)
4 Washer (3/8 x 1-5/8 inches)
2 Drawbar
2 Capscrew (1/2 x 4 inches)
2 Locknut (1/2 inch)
Assembling the Lift Arm to the
Machine
1. Align the hole in the lift-arm tube with the holes
in the arm brackets of the cross channels
13).
1. Locknut (3/4 inch)
2. Lift-arm tube
3. Lift-bail pin
2. Loosely assemble the lift arm to the cross
channels with
(Figure locknut (3/4 inch).
3. Align the hole in the tab of the lift-bail pin with
the threaded hole in the arm bracket
13), and secure the pin to the bracket with a
capscrew (5/16 x 3/4 inch).
4. Torque the locknut (3/4 inch) to 91 to 113 N∙m
(67 to 83 ft-lb).
5. Repeat steps
other side of the machine.
Assembling the Lift Cylinder to
the Lift Arm
1. Align the holes in the link, washers (1-1/8 x 2
inches), and the fitting of the lift-cylinder rod
(Figure
6
Figure 13
4. Arm bracket (cross
channel)
5. Capscrew (5/16 x 3/4 inch)
(Figure 13) the lift-bail pin and the
1 through 4 for the lift arm at the
14).
g322274
(Figure