Advertisement
AC power connection
drawing, depending on the wall outlet in the room.
Pull out the fuses and place the correct fuses in their sockets. See
Power selector plug
1
AC Power
input board
the table below for the correct type of fuses.
Re-insert the power input board and secure it with the retaining
screws.
Fuses
Warning !
For continued protection against fire hazard :
Replace with the same type of fuse.
Refer replacement to qualified service personnel.
AC power
Fuses
Switching on the projector
Push the power (mains) switch on the local keyboard to switch the
projector ON and OFF :
if the switch is pressed
if the switch is Not pressed
The projector can be started up in the 'operational mode' (image
displayed) or in the 'stand-by mode', depending on the position of the
'power-up' DIP switch on the controller unit (see p.5-2). This DIP
switch is set during installation by a qualified technician. If you want
to change this start up mode, call a qualified technician.
Power indication lamp :
OFF
: no power
Green : projector in operational mode
Red
: projector in stand-by mode
When switching on the projector, with the power switch or via the
stand-by key, the projector can start up in two ways if the "CRT run
in cycle" option is switched OFF :
a full white image (projector warm up) or
immediately image display.
The way of starting up can be set in the service mode.
5-4
Fuses
Order Number
: ON
: OFF
2
230V
Power selector on 230V
230 Vac
T6.3A/250V (2x)
120 Vac
T10A/250V (2x)
5976002 RETROGRAPHICS 808s 100299
120V
Power selector on 120V
R314145
R314154
Advertisement
