Installing The Tiller To The Tractor - Toro Wheel Horse 79375 Operator's Manual

Installation
8. Replace the drive shaft maintenance cover (if
removed).
7
6
Figure 9
1. Cable guide
2. Clip nut
3. Fan baffle bolt
4. Left hand lift arm pivot bolt
nut
5. Plastic fan baffle
Installing the Tiller to the
Tractor
1. Position the tiller on a level surface with enough
space behind it to accommodate the tractor.
2. Start the tractor and back it into position. Lower
the attachment lift and turn the ignition key to
"STOP" to stop the engine. Remove the ignition
key.
3. Place the jack shaft assembly between the tractor
wheels and oriented with the tiller as shown
(Fig. 10).
8
1
9
8
4
2
3
5
6. Right hand attachment lift
arm
7. Rear of tractor
8. Pivot bolt
9. Lift cable
Figure 10
1. Tiller
2. Jack shaft assembly
3. Lift cable
4. Tiller belt (short belt)
5. Idler pulley
4. Open the latches on the rear Attach–A–Matic .
Place the smaller bar of the jack shaft assembly
into the slots on the front of the rear
Attach–A–Matic
3
Figure 11
1. Smaller jack shaft bar
2. Rear Attach–A–Matic
1
7
3
6
5
8
4
9
6. Tiller hitch bar
7. Smaller jack shaft bar
8. Jack shaft/PTO drive belt
pulley
9. Larger jack shaft bar
(Fig. 11).
2
1
3. Rear
2
m–3491
m–3505