Toro Wheel Horse 79375 Operator's Manual page 9

Remove the Rear Transaxle Cover
Remove the transaxle cover from the back of the
tractor (Fig. 8).
1. Remove the two bolts and locknuts securing the
transaxle cover to the tractor frame.
Note: Save all parts and hardware for use
when reinstalling the transaxle cover.
Figure 8
1. Rear transaxle cover
Installing the Cable Guide
The cable guide can be installed from the underside
of the tractor. For more visibilty, the drive shaft
maintenance cover can be removed to aid in
installation.
1. Disengage the power take off (PTO), set the
parking brake and turn the ignition key to
"STOP" to stop the engine. Remove the ignition
key.
1
m–3436
POTENTIAL HAZARD
Rotating shaft or cooling fan can cause
injury.
WHAT CAN HAPPEN
Fingers, hands, feet, hair, etc. can get
caught by shaft or fan.
Loose clothing can get caught by shaft.
HOW TO AVOID THE HAZARD
Do not operate the tractor without the drive
shaft cover in place.
Keep hands and arms clear of rotating
shaft or fan.
2. Remove the two bolts in the plastic fan baffle
(Fig. 9) and remove the baffle.
3. Remove the clip nut from the left side of the
plastic fan baffle and install over the hole in the
bent tab of the cable guide (Fig. 9).
4. Remove the nut from the pivot bolt on the left
hand attachment lift arm (Fig. 9). Leave the bolt
in place.
5. Install the rear hole of the cable guide to the left
hand lift arm pivot bolt and replace the nut
loosely (Fig. 9).
6. Reinstall the plastic fan baffle with one of the
previously removed bolts in the right hand side
only (Fig. 9). Leave the bolt loose.
7. Align the front of the cable guide with the hole
in the left hand side of the plastic fan baffle and
reinstall the other bolt previously removed.
Tighten all bolts and nuts securely.
Installation
7