Toro Wheel Horse 79375 Operator's Manual page 12

Installation
1
5
Figure 14
1. Lift cable
2. Clevis
3. Attachment lift arm
9. Route the lift cable under the cable guide and
over the rear axle (Fig. 9).
10. Connect the lift cable to the trunnion by
threading the trunnion onto the lift cable
(Fig. 15).
11. Attach the trunnion to the hole in the tiller lift
cable mount with a washer and hairpin cotter
(Fig. 15).
Note: There should be slack in the cable so
the tiller will drop into the ground.
The amount of cable that is threaded
into the trunnion determines the
maximum depth of tilling and lift
height.
10
3
4
2
m–3504
4. Clevis pin 5/16" x 1" (25
mm)
5. Hairpin cotter
3
2
Figure 15
1. Lift cable
2. Trunnion
3. Locknut
12. Secure the lift cable to the trunnion with a
locknut (Fig. 15).
13. Remove the tractor grille by pulling it out
toward you.
POTENTIAL HAZARD
Components under the hood will be hot if
the tractor has been running.
WHAT CAN HAPPEN
Touching hot components can cause burns.
HOW TO AVOID THE HAZARD
Allow the tractor to cool before performing
maintenance or touching components
under the hood.
14. Route the PTO drive belt around the jack shaft's
PTO pulley (Fig. 10), then through the center of
the pulley box between the two pulleys.
15. Release the belt tension release arm of the pulley
box housing and swing it out toward you (Fig.
18).
5
4
1
m–3503
4. Washer
5. Hairpin cotter