Toro Wheel Horse 79375 Operator's Manual page 11

5. Open the latches on the mid Attach–A–Matic .
Install the larger bar at the other end of the jack
shaft assembly to the mid Attach–A–Matic .
Then turn the lever of the Attach–A–Matic
counterclockwise to lock the jack shaft assembly
to the tractor (Fig. 12).
Note: The rear Attach–A–Matic
to be loosened and realigned with the
mid Attach–A–Matic
jack shaft assembly. Tighten the rear
Attach–A–Matic bolts
1
Figure 12
1. Attach–A–Matic button
2. Attach–A–Matic lever
6. Place the tiller hitch bar into the slots in the rear
of the rear Attach–A–Matic . Press on the
latches at the rear until they lock both the tiller
and the jack shaft assembly in place (Fig. 13).
may need
to accept the
securely.
3
2
4
m–3502
3. Lock
4. Larger jack shaft bar
4
2
Figure 13
1. Smaller jack shaft bar
2. Tiller hitch bar
7. Install the tiller belt (short belt) between the
tiller and jack shaft assembly (Fig. 10). Route
the belt under the ilder pulleys and over the jack
shaft pulley.
8. Attach the clevis end of the lift cable to the rear
hole in the tractor's attachment lift arm located
just in front of the previously installed cable
guide (Fig. 14). Insert a clevis pin and hairpin
cotter.
Note: Attachment lift arm may be different
than shown in Fig. 14. On some
models there may be only a single hole
in which to mount the clevis.
Installation
3
1
3. Rear Attach–A–Matic
4. Rear
9