Installation
Figure 6
1. Snap ring
2. Pin
Preparing the Tractor's Attachment Lift
If you have been using a mower, secure the tractor's
attachment lift arms in the raised position.
1.
Start the tractor.
2.
Raise the attachment lift.
3.
Set the parking brake and turn the ignition key to
"STOP" to stop the engine. Remove the ignition
key.
4.
Install a 3/8" x 1" (25 mm) clevis pin into each
side of the lift assembly in the positions shown
in Figure 7. Secure them with (2) hairpin
cotters.
6
1
3
4
2
2314
3. Drawbar
4. Spacer (2)
1
Figure 7
1. Clevis pin 3/8" x 1" (25
mm)
These pins must be installed when operating with a
blade, snowthrower, or tiller attachment.
Note:
The pins are removed to attach a
mower.
2
m–3433
2. Hairpin cotter