Advertisement
1.
Plug in the sealer. Set the power switch to "on".
2. Adjust the timer to the minimum setting necessary for poly bag thickness.
3. Insert poly bag between pressing lips. Press the foot pedal to begin
sealing. (See Figure 5)
4. When the light turns off, sealing is complete. Wait 1 to 2 seconds to allow
the seal to cool, then release the foot pedal.
noTe: The sealing time is automatically controlled by the timer.
you can leave the unit plugged in and turned on between seals.
Power is only used during sealing.
max. Seal Thickness
model
RePAIR KIT
REPLACInG TEFLOn ROLL
1. Turn off power and unplug sealer.
2. Remove pressing plate and loosen teflon clips.
(See Figure 6)
3. Cut off a new section of teflon tape. Replace
pressing plate and tape.
PAGE 3 OF 4
oPeRATInG InSTRucTIonS
model
Impulse Power
Seal Width
max. Seal Length
Heat Time
Weight
Dimensions
27.75 x 15.75 x 35.5"
RePlAcemenT PARTS
H-86
H-87
H-89
H-204
H-173
H-174
Figure 6
Pressing
Plate
Teflon
Clips
SPecIFIcATIonS
H-86
520 W
2 mm
24"/600 mm
12"/300 mm
16 mil
~0.2–1.7 sec.
~0.2–1.7 sec.
75 lbs.
15 x 13.75 x 35.5"
4. Adjust teflon screw to tighten teflon roll. (See Figure 7)
5. Tighten teflon clips.
REPLACInG HEATInG ELEmEnT
1. Turn off power and unplug sealer. Release teflon clips.
2. Remove screws to release heating element.
3. Remove old heating element and replace with the
new one.
4. Reattach and tighten the teflon tape.
H-87
H-89
380 W
454 W
2 mm
2 mm
18"/450 mm
16 mil
16 mil
~0.2–1.7 sec.
51 lbs.
62 lbs.
21.25 x 15 x 35.5"
Heating
Teflon
Element
Tape
Teflon
Screw
Pressing
Plate
Figure 5
Figure 7
Teflon
Clip
0315 IH-86
Advertisement
