Table of Contents
Advertisement
Installation instructions / ACS-2 plus
Table 2: Protocol and Baud rate
6
7
Function
0
0
Setup via terminal
program
0
1
9-Bit-Protocol = factory
setting
1
0
DIN-66090-Protocol
1
1
RDT-Protocol
0 = OFF
1 = ON
Table 3: Service function
8
Function
0
Factory setting (= service function not active / switch positions 1 - 7 according to table 1 and 2)
1
Service function (meaning of the switches 1 - 7 see table 4)
Warning!
Table 4: functions with the service switch activated
1
2
3
1
1
1
If the switch 8 ON state is detected, LED 1 on the CPU board flashes green until the next reset is carried out.
The flashing green LED indicates that a function is in process. When this LED lights permanently, the function
has been completed
Procedure of bootstrapping:
1. Set all DIP switches to ON
2. Reset (reset push-button)
3. LED 1 flashes (wait)
4. LED 1 lights permanently
5. Switch DIP S1 to the required
position (baud-rate, address,
protocol, etc.)
6. Reset (reset push-button)
Switch 8 is reserved for service level functions and should
not be changed from the factory setting of OFF. Changing the
switch setting may cause loss of data.
Do not change factory settings!
4
5
6
7
1
1
1
1
Connected to
e. g. Event protocol (for
ethernet)
Interface converter
COMx
Modem
ISDN card
8
Function
1
Bootstrap
Comment
The switch positions 1-7 are
ignored (see chapter 11).
With these protocols, the
baud rate is set at 19200.
29
Advertisement
Table of Contents
