Manual Dispensing Of Hot Water; Automatic Dispensing Hot Water - Astoria AL Series Use And Maintenance Manual

To keep the steam nozzle tips in perfect working order, it is
advisable to carry out a brief dry delivery after each use. Keep the
tips clean at all times using a cloth dampened in lukewarm water.
The use of the steam dispensing point (steam nozzle), must always
be preceded by condensation draining for at least 2 seconds.
Leave the steam nozzle immersed in the milk only for the heating
time required.
Do not open the steam tap with the steam spout immersed in milk
while the machine is off.

Manual dispensing of hot water

6.10
Place the jug under the hot water
nozzle;
rotate the tap knob counter-
clockwise;
the delivery of hot water will
be proportional to the tap's
opening;
to end the dispensing, rotate the
tap's knob clockwise;
Avoid contact with the hot water nozzle, do not direct your hands
or other body parts towards the hot water nozzle ends.
USER manual
MILK

Automatic dispensing hot water

6.11
PROGRAMMING
T h e m a c h i n e i s p r o -
grammed by default. Should
the doses need to be modified,
proceed as follows:
Move the programming
lever X (see note *) located
under the body RH front
panel, to the ON position;
position the jug under the hot
water spout;
PROG.
press button for at least 5
STOP
seconds, until all leds of the dose
buttons are lit;
Press the hot water dispensing
button (Y);
to confirm the dose press but-
PROG.
ton ;
STOP
on concluding the programming,
return the programming lever X
(see note*) to the OFF position.
NOTE ( )
*
In some models the program-
ming lever X is not fitted; to enter
the programming mode, press
PROG.
button for at least 5 sec-
STOP
onds, with all push-button panel
leds switching on. To confirm the
PROG.
dose, press button
STOP
In other models, to access pro-
gramming it is necessary to use
a special key switch.
To exit programming it is suf-
ficient to wait a few seconds.
Y X
PROG.
STOP
Y
.
PROG.
STOP
39 160
of