Get Stored Snapshots From Flash Memory; Move Positioning Device In Pt Direction; Query Status Of Digital Inputs; Drive Digital Outputs - Vivotek NetworKam IP2111 User Manual

Get stored snapshots from Flash memory

/cgi-bin/snapshot.jpg?file=<filename>
snapshot stage
snapshot before event
snapshot upon event
snapshot after event

Move positioning device in PT direction

<direction>: up, left, right, down, home
/cgi-bin/control.cgi?cam=<input source>&move=<direction>

Query status of digital inputs

/setup/getdi.cgi
NetworKam will return status of the digital input in one line.

Drive digital outputs

/setup/setdo.cgi?do1=<state>
, where state is H, L. H means NC connected with COMMON and L means NO connected with
COMMON.
For example, http://192.168.0.201/setup/setdo.cgi?do1=h will command NetworKam, with IP address of
192.168.0.201, to set digital output to connect NC with COMMON.

Clear data mode serial port driver

This URL applies to the attached serial port device including supported PTZ cameras or non-supported
custom cameras. Note the serial port settings of custom cameras must be correctly defined in advance.
Send command to device attached to COM
/cgi-bin/senddata.cgi?data=123456,ABCDEF&flush=yes&wait=1000&read=6
This hyperlink will inform NetworKam to send out binary format commands to the COM with "0x12,
0x34, 0x56" followed by "0xAB, 0xCD, 0xEF". Each comma separates the commands by 200
milliseconds. "flush=yes" means the receive data buffer of COM port must be cleared before read. Then
filename
pre
trg
pos
78
www.vivotek.com
T: 886-2-22404099
F: 886-2-22404097