Vivotek NetworKam IP2111 User Manual page 57

NetworKam is able to monitor the video signal if the objects in the image are moved. To use motion
detection, check "Upload snapshot while motion detected" and then click on
to tune "Object size" and "Sensitivity" to reduce the false alarm. The larger object size and lower
sensitivity will make NetworKam ignore small variations in images.
To configure DI/DO, there are four extended I/O scripts. Motion detection can be considered here to drive
digital outputs. The format will explain below and no space is needed among each parameters. It also
applies to CONFIG.INI when using FTP.
<command format>
["Digital input number""Digital input state"]["operator""Digital input number""Digital input state"...]
["operator"{"hour":"minute":"second"}...]["operator""M"]="Digital output number""Digital output
state"
56
www.vivotek.com
T: 886-2-22404099
F: 886-2-22404097