Zumtobel ONLITE local SB 128 Controller Operating Instructions Manual page 51

Assigning the luminaires order using a GSM mobile phone
Instead of setting up luminaires using the touch panel control keys, a GSM mobile phone
can be alternatively used. The steps above should be followed but using the mobile
phone buttons for data input.
A prerequisite for this method is that an ONLITE GSM module is connected to the
ONLITE local SB 128 Controller.

Prior to luminaires setup, the number of
the GSM modules should be dialed by
using a tone dialing phone. Instead of
using the touch panel keys, the phone
buttons can serve to setup the luminaires.
The following mobile phone buttons
correspond to the keys on the touch panel:
Touch panel
assign
Start / Stop
<< back
>> next
Notes
The ONLITE GSM module confirms the successful connection establishment by
an acoustic signal. Then, a PIN code has to be entered (refer to section 10.2 on
page 52). This is additionally indicated by the flashing green LED on the ONLITE
local GSM module.
The setup of the luminaires has to be started directly at the ONLITE local SB 128
Controller. Access via GSM mobile phone is only possible while the assignment
dialog is active. All other steps during the setup procedure have to be performed
directly at the ONLITE local SB 128 Controller.
ONLITE local SB 128 Controller
Mobile phone
Button 1
Button 5
Button 4
Button 6
49