Table of Contents
Advertisement
3
Installation
Warning!
Only qualified electrical specialists may perform work on the 230 V mains supply.
Wiring of current-carrying lines as well as signal and control lines must be done
in accordance with the relevant guidelines and norms.
National guidelines and regulations applicable in the country in which the system
is being installed and operated have to be observed.
3.1
Who is allowed to perform the installation?
In principle, the installation may only be performed by suitably qualified professional
electrical specialists who have been briefed on local and operational conditions. Other
persons may only perform the installation under the supervision and control of authorized
technical staff, after having received appropriate briefing and if the tasks and jobs have
been fully understood.
3.2
Mounting the ONLITE local SB 128 Controller
The ONLITE local SB 128 Controller can be mounted using the drilling holes in the rear
panel or on a top-hat rail according to EN 50022.
The required drilling hole distances can be found in the accompanying drawing.
The drilling hole diameter is 3.5 mm.
Figure 4:
Mounting the SB 128 Controller
14
ONLITE local SB 128 Controller
Advertisement
Table of Contents
