Silvercrest TRITACARNE SFW 350 D3 Operating Instructions Manual page 60

7) Replace the pattern strips 1 back in to the front of the biscuit attachment 1 .
Ensure that the grip on the pattern strips 1 points away from the appliance .
If it does not, you will not be able to adjust the pattern, which is located
directly on the grip .
8) Assemble the meat grinder casing 6 as described under "Assembling the
meat grinder" .
9) To dismantle it, you must first remove the pattern strips 1 before you can
screw the ring clamp t open and take the biscuit attachment 1 back out .
Fitting the strainer attachment
Unfold the fold-out page – it contains the step-by-step illustrations for assembling
the appliance .
1) Remove the meat grinder casing 6 as described in "Assembling the meat
grinder" .
2) Remove any attachments that might be fitted and clean the meat grinder
casing 6 .
NOTE
► The transport screw q and the cross blade e with the spring w are not
required for the strainer attachment! Remove these from the meat grinder
casing 6 if necessary .
3) Push the plastic screw 9 into the meat grinder casing 6 .
4) Push the strainer sieve 0 over the plastic screw 9 so that the tabs on the
strainer sieve 0 fit into the recesses in the meat grinder casing 6 . The holes
of the strainer sieve 0 should be facing downwards .
5) Once everything has been correctly attached, roll the ring clamp t over the
strainer sieve 0 and screw it on hand-tight .
6) Fit the meat grinder casing 6 as described in "Assembling the meat grinder" .
7) Undo the locking clamp 7 on the tomato outlet 8 .
8) Place the tomato outlet 8 under the strainer sieve by pushing the tip of the
strainer sieve 0 through the small hole in the tomato outlet 8:
SFW 350 D3
GB │ MT │ 57 ■