Silvercrest TRITACARNE SFW 350 D3 Operating Instructions Manual page 58

5) Place your selected cutting disc r into the meat grinder casing 6 so that
the fixings on the cutting disc r are located in the openings in the meat
grinder casing 6 .
6) After everything has been correctly assembled, screw the ring clamp t
back on hand-tight .
7) The ready-assembled meat grinder ca sing 6 is connected by a bayonet
connector to the motor unit 5:
– Insert the meat grinder casing 6 into the motor unit 5 such that the
arrow on the meat grinder casing 6 lies against the symbol
motor unit 5 . The locking button o presses itself in (Fig . B) .
– Lightly press the meat grinder casing 6 in and at the same time turn
the feeding shaft on the meat grinder casing 6 into the middle position
(Fig . B) so that the arrow on the feeding shaft points to the symbol
When the meat grinder casing 6 engages, the locking button o
springs out .
– Finally, place the feeding tray 3 on top of the feeding funnel .
– To dismantle it, press the locking button o and turn the feeding funnel
to the right (Fig . B)
Assembling the sausage stuffer attachment
Unfold the fold-out side - there you will find the step-by-step illustrations for as-
sembling the appliance .
1) Remove the meat grinder casing 6 as described under "Assembling the
meat grinder" .
2) Dismantle all parts which are fitted to/in the meat grinder casing 6 and
clean them .
3) Coat all metal parts with cooking oil .
4) Put the transport screw q, the spring w and the cross blade e back into
the meat grinder casing 6 .
5) Insert the sausage disc u so that the fixings on the sausage disc u are
located in the openings in the meat grinder casing 6 .
6) Then place the sausage stuffer attachment z before the sausage disc u .
7) Screw the ring clamp t on hand-tight .
8) Assemble the meat grinder casing 6 as described under "Assembling the
meat grinder" .
SFW 350 D3
. You can now pull the meat grinder casing 6 out .
on the
.
GB │ MT │ 55 ■