Preparation For Piping Work; Read Before Servicing - Mitsubishi Electric PUHY-P250YNW-A Service Handbook

[1-1 Preparation for Piping Work ]

1-1

Preparation for Piping Work

1 Check Before Servicing
1-1-1

Read before Servicing

1. Check the type of refrigerant used in the system to be serviced.
Refrigerant Type
Packaged air conditioner for computer room application PFD series: R410A
Note: The unit can be operated only in the cooling mode when combined with PFD series.
2. Check the symptoms exhibited by the unit to be serviced.
Refer to this service handbook for symptoms relating to the refrigerant cycle.
3. Thoroughly read the safety precautions at the beginning of this manual.
4. Preparing necessary tools: Prepare a set of tools to be used exclusively with each type of re-
frigerant.
For information about the correct use of tools, refer to the following page(s). [1-1-2 Tool Preparation]
5. Verification of the connecting pipes: Verify the type of refrigerant used for the unit to be moved
or replaced.
Use refrigerant pipes made of phosphorus deoxidized copper. Keep the inner and outer surfaces of the pipes clean and free
of such contaminants as sulfur, oxides, dust, dirt, shaving particles, oil, and water.
These types of contaminants inside the refrigerant pipes may cause the refrigerant oil to deteriorate.
6. If there is a leak of gaseous refrigerant and the remaining refrigerant is exposed to an open
flame, a poisonous gas hydrofluoric acid may form. Keep workplace well ventilated.
CAUTION
Install new pipes immediately after removing old ones to keep moisture out of the refrigerant circuit.
The use of refrigerant that contains chloride, such as R22, will cause the refrigerating machine oil to deteriorate.
BS_01_C
1
chapter 1 -