Troubleshooting And Error Code; Troubleshooting; Error Code - Samsung MS23F301T Series Owner's Instructions & Cooking Manual

troubleshooting and error code

TROUBLESHOOTING

Becoming familiar with a new appliance always takes a little time. If you
have any of the problems listed below, try the solutions given. They may
save you the time and inconvenience of an unnecessary service call.
The following are normal occurrences.
• Condensation inside the oven
• Air flow around the door and outer casing
• Light reflection around the door and outer casing
• Steam escaping from around the door or vents
The food is not cooked at all
• Have you set the timer correctly and pressed the Start/+30s (
button?
• Is the door closed?
• Have you overloaded the electric circuit and caused a fuse to blow or a
breaker to be triggered.
The food is either overcooked or undercooked
• Was the appropriate cooking length set for the type of food?
• Was an appropriate power level chosen?
The oven causes interference with radios or televisions
• Slight interference may be observed on televisions or radios when the
oven is operating. This is normal.
• Solution: install the oven away from televisions, radios and aerials.
• If interference is detected by the oven's microprocessor, the display may
be reset.
• Solution: Disconnect the power plug and reconnect it. Reset the
time.
The light bulb is not working.
• The Light bulb should not be replaced in person for safety reasons.
Please contact nearest authorised Samsung customer care, to arrange
for a qualified engineer to replace the bulb.
MS23F301TAK_SM_DE68-04238A_EN.indd 29
Sparking and cracking occur inside the oven (arcing)
• Have you used a dish with metal trimmings?
• Have you left a fork or other metal utensil inside the oven?
• Is aluminum foil too close to the inside walls?
If the above guidelines do not enable you to solve the problem, then
contact your local SAMSUNG customer service centre.
Please have the following information read;
• The model and serial numbers, normally printed on the rear of the
oven
• Your warranty details
• A clear description of the problem
Then contact your local dealer or SAMSUNG aftersales service.
)

ERROR CODE

"SE" message indicates.
• The "SE" message is Clean the keys and check if there is water on
the surface around key. Turn off the microwave oven and try setting
again. If it occurs again, call your local SAMSUNG Customer Care
Centre.
English - 29
2013-10-04 10:18:36