Troubleshooting And Error Code; Troubleshooting; Error Code - Samsung MC32F604TCT Owner's Instructions & Cooking Manual

troubleshooting and error code

TROUBLESHOOTING

Becoming familiar with a new appliance always takes a little time. If you have any of
the problems listed below, try the solutions given. They may save you the time and
inconvenience of an unnecessary service call.
The following are normal occurrences.
• Condensation inside the oven
• Air flow around the door and outer casing
• Light reflection around the door and outer casing
• Steam escaping from around the door or vents
The food is not cooked at all
• Have you set the timer correctly and pressed the Start/+30s button?
• Is the door closed?
• Have you overloaded the electric circuit and caused a fuse to blow or a breaker to be
triggered.
The food is either overcooked or undercooked
• Was the appropriate cooking length set for the type of food?
• Was an appropriate power level chosen?
Sparking and cracking occur inside the oven (arcing)
• Have you used a dish with metal trimmings?
• Have you left a fork or other metal utensil inside the oven?
• Is aluminum foil too close to the inside walls?
The oven causes interference with radios or televisions
• Slight interference may be observed on televisions or radios when the oven is
operating. This is normal.
• Solution: install the oven away from televisions, radios and aerials.
• If interference is detected by the oven's microprocessor, the display may be reset.
• Solution: Disconnect the power plug and reconnect it. Reset the time.
The light bulb is not working.
• The Light bulb should not be replaced in person for safety reasons. Please contact
nearest authorised Samsung customer care, to arrange for a qualified engineer to
replace the bulb.
MC32F604TCT_ZS_DE68-04173N-00_EN.indd 37
Smoke and bad smell when initial operating.
• It's a temporary condition by new component heating. Smoke and smell will
disappear completely after 10 minutes operation. To remove smell more quickly,
please operate microwave oven with putting lemon formation or lemon juice in the
cabinet.
If the above guidelines do not enable you to solve the problem, then contact your
local SAMSUNG customer service centre.
Please have the following information read;
• The model and serial numbers, normally printed on the rear of the oven
• Your warranty details
• A clear description of the problem
Then contact your local dealer or SAMSUNG aftersales service.

ERROR CODE

"E-24" message indicates.
• The "E-24" message is automatically activated prior to the microwave oven
overheating. Should the "E-24" message be activated, then depress the "Stop/Eco"
key to utilize the initialization mode.
For any codes not listed above, or if the suggested solution does not solve the
problem, contact your local SAMSUNG Customer Care Centre.
English - 37
2014-10-13 5:57:31