Download Print this page

GRAUPNER 4412 Operating Instructions Manual page 19

With infra-red remote control system supplied

Advertisement

Available languages

Available languages

transmitters, interference etc., and this could cause the motors to burst into life
unexpectedly.
Before every flight ensure that the remote control system is working properly and has
adequate range. This means checking that the transmitter controls the model's
functions at a reasonable range on the ground.
Batteries
Never use faulty or damaged cells or batteries consisting of different cell types,
mixtures of old and new cells, or cells of different makes.
Exhausted and faulty dry or rechargeable cells must not be discarded in the
household waste. Take old batteries back to your model shop, or to your nearest
specialist toxic waste disposal centre.
Gluing different materials
The following table lists typical glued joints and the recommended adhesives. It is
only a guide, and does not claim to be comprehensive.
Materials
Foam to foam
Read and observe the instructions supplied with all adhesives! The building
instructions inform you when to use particular glues. If you wish to use white
spirit or other solvent as a cleaning agent, note that special safety measures
are required. Read the instructions supplied with these materials.
Note
Important: it is essential to keep the model's weight to a minimum, so please be
sparing at all times when applying adhesives.
Read the instructions supplied with the various glues before using a particular type
on the model. You will find other adhesives in the main Graupner FS catalogue.
Remote control system for the MICRO FILOU
Infra-Red remote control system, included in the set.
Six dry cells, Order No. 3426, are required for the transmitter. Rechargeable cells of
the same size can also be used; see the main FS catalogue.
RC functions
Differential throttle control for steering
Motor speed (throttle)
Specification
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Änderungen vorbehalten! Keine Haftung für Druckfehler!
Typical joint
Wing
19
Adhesive, Order No.
UHU por, 959, or
cyano-acrylate, 5821, with
activator, 953.150
01/2008

Advertisement

loading

This manual is also suitable for:

Micro filou