Replacing The Circuit Board Batteries - Acroprint ATR360 User Manual

Replacing the Circuit Board Batteries

The ATR360 is equipped with (2) CR2032 3v Lithium Coin Cell batteries: one battery is on the
Main board and the other is on the Display board. The batteries should last approximately 1.5 to
2 years under normal operating conditions. Do not attempt to replace these batteries as it will
void your warranty. If your clock is already out of warranty you can attempt to replace the
batteries yourself but note that you could damage the boards if you short out any components on
the circuit board. Avoid using metal objects to remove the batteries.
Note: All Time Recorder settings will be reset to factory defaults as soon as the Main board battery
is removed.
Back Case
Main Board Battery
1. Unplug clock.
2. Remove the front cover and the two screws that connect the front and back case. Remove
the front case and lay it flat being careful not to pull any wires or cables loose.
3. To remove batteries press the metal retaining clip away from the battery. The battery should
pop up. It may be necessary to use a small probe to pop the battery out.
4. Replace the batteries and re-assemble clock.
Front Case
Display Board Battery
23