Add User; Badge Setup - Acroprint ATR360 User Manual

Add User

5. Press enter
a. Users must be assigned a number user number. You may add up to 150 users and
5 administrators
6. To assign the user a number use the up and down buttons to change each digit. Start with
first digit. (For the number 001 you will start with 0). Press enter to go to the next digit.
a. User numbers will appear Uxxx and can be assigned numbers U001-U150
b. Administrator numbers will appear Axxx and can be assigned numbers A301-A305
7. When you have completed assigning the user, while the last digit is flashing press and
hold the enter button for 3 seconds
8. The LED display will change to F.P.x.x
9. To register a finger print the last digit should be flashing
10. Place the finger on the finger print reader. 3 samples must be giving. If the finger print is
accepted the LED Display will change (F.P.1.1, F.P.1.2, F.P.1.3) after all 3 samples are
giving and accepted the message PASS will appear
11. Now select a second finger for a back up print
a. This is for situations where the primary finger cannot be used because of injuries to
the finger or the reader is unable to read the finger print
12. The LED display will read F.P.2.1
13. Complete step 10 to register the back up print
14. A third back up print may be registered or press cancel
15. Complete steps 5-13 to add another user or press cancel, down, enter to exit

Badge Setup

1. Remove top cover
2. Locate the finger print switch located to the left of the finger print reader
3. Move the switch to the up position to turn on the finger print reader.
4. Press the "FP Setup" button until ADD.U appears in the front LED display
a. If no activity is detected within 30 seconds the setup program will be terminated
and the "FP Setup" up button must be pressed again
5. Press enter
a. Users must be assigned a number user number. You may add up to 150 users and
5 administrators
6. To assign the user a number use the up and down buttons to change each digit. Start with
first digit. (For the number 001 you will start with 0). Press enter to go to the next digit.
a. User numbers will appear Uxxx and can be assigned numbers U001-U150
b. Administrator numbers will appear Axxx and can be assigned numbers A301-A305
7. To skip finger print recognition press cancel
a. The third digit should be flashing
8. Press the down button the LED display will read "rFId"
9. Press enter the LED display will read "CARD"
10. Scan the card. If the card is successfully scanned the LED display will indicate "PASS"
11. Complete steps 5-10 to add another user badge or press cancel, down, enter to exit
9