Advertisement
Quick Links
RESEARCH&DEVELOPMENT OF AMERICA, INC.
5420 DANIELS STREET STE A, CHINO CA., 91710 · (800) 634-9166 · (909) 628-4722 · FAX (909) 591-2198
www.yoshimura-rd.com
FENDER ELIMINATOR KIT
070BG149500
K awasaki
Z900RS
THIS PRODUCT IS NOT DOT APPROVED.
Yoshimura R&D of America, Inc. is not liable or responsible for any resulting event caused by the
!
!
installation of this product. Check with local laws and regulations for compliance prior to
installation and use. This product is not intended for use on public highways.
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Yoshimura 070BG149500
Summary of Contents for Yoshimura 070BG149500
- Page 1 Z900RS THIS PRODUCT IS NOT DOT APPROVED. Yoshimura R&D of America, Inc. is not liable or responsible for any resulting event caused by the installation of this product. Check with local laws and regulations for compliance prior to installation and use. This product is not intended for use on public highways.
- Page 2 Fender eliminator spacer is to be used if side reflector bracket is not installed. ** Not shown on diagram. *** The Yoshimura Universal Turn Signal Bracket Kit is to be used with aftermarket stud-mounted turn signals and is sold separately.
- Page 3 Using the BN-SSS-22-18 butt connectors provided in the kit, connect the Yoshimura license plate light wires to the stock license plate light wires as follows: 2. Using the stock hardware, install left and right turn signals onto (No.
- Page 4 a) Strip the stock fender light wire ends 1/4” - 1/2” and insert into BN-SSS-22-18, butt connectors provided in the kit. b) Center the spliced wire ends in the middle and using a heatgun or lighter, apply heat evenly on the outer edges of the butt connector to shrink and hold wires in place.
Need help?
Do you have a question about the 070BG149500 and is the answer not in the manual?
Questions and answers